12 gang - $20

satin/red on/off- $7.99ea.
black/red on/off- $6.50ea.
satin/green on/off- $8.30ea.
standard on/off chrome toggle- $3.99
rubber boot for toggles - $1.80

CARLING CONTURA ROCKER SWITCHES

Actuators available with red lens, blue lens, no lens and other custom styles. Contura II, III, IV, V

See www.Carlingtech.com for more information

All terminals have closed tubing for maximum corrosion resistance, except for the 4/0 as shown

12VDC warning buzzer horn

HARNESS # 1 - - - SOLD OUT   

HARNESS # 2

13' Length from switch panel to aft . Nice harness for smaller fishing boat with battery mounted under console or within 5' of main switch panel and with the following accessories and equipment

• Trim tabs
• Integral fuel tank with sender
• Bilge pump
• Navigation lights

The harness is basically 3 bundles. ALL MARINE GRADE WIRE. 16 wire total.

• Bundle 1: Trim tab harness (blue, yellow, green, red), automatic bilge pump (3 brown), also 2 black wires. 13' in length.
• Bundle 2: Battery wires RED and BLACK 12ga. with large ring terminals and a 30 amp AGC fuse in a waterproof housing. Also as part of this bundle is a brown/red stripe wire with ring terminal and 7.5 amp fuse for the bilge pump. This harness is approximately 5' in length from the main plugs which are designed to plug into the switch panel. Also has a blue-black pair for a navigation light
• Bundle 3: Contains black-pink for fuel sender. 9' in length.

BH Electronics for Maverick Boat Co. 

$49

14' Length from battery to plugs. Good harness for center console or small cuddy cabin boat with aft mounted battery(batteries) and the following accessories and equipment: 

• Trim tabs
• Integral fuel tank with sender
• Bilge pump
• Livewell
• Navigation lights

The harness is basically 3 bundles. ALL MARINE GRADE WIRE. 16 wire total.

• Bundle 1: Follows battery/trim tab bundle. Contains gray/white stripe-black for stern/anchor light, auto bilge pump wires, and livewell wires. 10' in length from plugs.
• Bundle 2: Battery wires RED and BLACK 12ga. with large ring terminals and a 30 amp ATC fuse in a waterproof housing. Also as part of this bundle is a brown/red stripe wire with ring terminal and 7.5 amp fuse for the bilge pump. Trim tab harness (blue, yellow, green, red)
• Bundle 3: Contains black-pink for fuel sender. 9' in length. Also has a gray-black pair that is about 18' long for the bow light.

BH Electronics for Maverick Boat Co. 

$49

6-1/2' length. Designed for small fishing, flats, or bass boat. with the following accessories and equipment: 

• Trim tabs
• Livewell or manual bilge pump
• Navigation lights

Designed to wire directly to your fuse panel. All wires have a shrink wrapped spade terminals.

• 12ga. red and black wires with ring terminals installed. Red is fused with a waterproof fuse holder.
• Trim tab wiring and stern/anchor light wires extend the full length.
• Wiring for 2 pumps or accessories
• Wiring for bow light extends about 10' forward for a total of 16' from battery to bow light.
• Also includes positive and negative jumper wires for the back side of the switches. (switches and panel not included)

BH Electronics for Maverick Boat Co. 

$10

14' Length from battery to switch panel Great for center console or cuddy cabin up to around 28' with the following accessories and equipment:    

• Integral fuel tank with sender
• Automatic bilge pump
• Aerator
• 2 Courtesy lights
• Bow light
• Stern light

ALL MARINE GRADE TINNED COPPER WIRE. There is a main 8 pin connector plug that would connect to your existing switch panel and fuse block. The plug will be located near your dash panel. Below is a list of the wires and their lengths from the plug:

1. courtesy light wires  - 4'
2. Bow light wires 15'
3. Fuel sending unit wires 8'
4. Aerator wires 11-1/2'
5. Bilge pump wires 11-1/2'
6. Stern light wires 13'
7. Main red 10ga wire to battery with in-line 20a fuse and waterproof housing:  14'

The wires have heat shrink connectors crimped to the ends for ease of connection to your accessories or in case you need to extend the wires at all. All wires are also labeled

BH Electronics for Scout Boat Co.  

$79         

Heavy duty harness. 15' from switch panel plug to battery, bow light 15' in opposite direction. Great harness for Any size boat! 

1. Heat shrink butt connectors already installed and ready to crimp.
2. Battery connections: 6ga. positive and negative with a 40Amp "short stop" thermal resetting circuit breaker runs up to a power post at dash, 16ga brown for auto bilge pump with fuse, 10ga positive with 30amp "short stop" thermal resetting circuit breaker supplies the switch panel.
3. stern light
4. Livewell pump
5. fuel tank harness pink/blk
6. bow light 14ga. pos and neg
7. courtesy lights
8. ground bus bar
9. Positive power post has the 6 ga. cable from the battery. Two 10ga leads to supply cabin electric or e-box electric, etc.
10. 2 more lighting leads for dash area?
11. 8 pin harness plug for dash area which includes power and ground.

Harness for T-top or hardtop electronics box, second station/flybridge or other remote location from main dash panel.

1. 8 gauge tinned copper main leads are 15' in length
2. Negative wire terminates at a 12 terminal bus bar
3. Positive wire terminates at 4 port ATC fuse block with 3,5,10, 20 amp fuses
4. 2 switches pre-wired for spreader lights and other lights.
5. Also includes wires for masthead light.

center console or cuddy cabin fishing boat up to 25' with aft mounted batteries.

15' from battery leads to switch panel plugs. positive and negative battery leads are 10ga. There are 2 brown leads with inline fuses for pumps that wire direct to battery. includes negative bus bar. 10 pigtails supply bilge pump, livewell pump, washdown pump, courtesy lighting, navigation lights, and other accessories. The pigtails extend about 4' to 9' from the battery and each pigtail includes a power wire and a ground wire. Fuel tank harness and bonding wire also included.

Full boat harness with switch/breaker panel! Designed for Cobia 27' and 31' boats... 15' from the battery to plug at the console.

1. Full switch panel 7-1/4" x 6-1/2" with 8 switches and circuit breakers, horn 10A, nav lights 5A, cockpit lights 5A, fishbox macerators 20A, livewell 5A, bilge pump 10A, washdown 15A, accessory 10A
2. All wiring is heavy duty
3. Main battery leads are 1 Gauge. red-positive, yellow ground
4. includes negative bus bar, positive power post and plug connector to plug in to switch panel.
5. Full stereo and speaker harness. designed for JBL marine stereo, but will work with anything.
6. Macerator wiring can be used for extra pumps or livewells. Nice heavy 12ga wire
7. Fuel tank harness
8. WIRES ARE LABELED!

Harness only - $150

Panel only - $120

Bennett interrupt relay IR 1000 - prevents blown circuit breakers when accidentally trying to tell the pump to turn both ways by pressing an up and down switch simultaneously. Has plug connectors to easily insert into the harness at the pump connector.